Thought of the day.

Putting plan together to change my two ball joint (failed mvi lol) plus rear lca... since buddy also told me the bushings in them are pretty shot.... aahhh welll, upgrade time :D gahhaha....
 
2nd annual Hot Pursuit BBQ smoke competition today was a good turnout , 11 smokers and the Valley Cruisers were there for a bit of a show and shine with free ribs, Pork butt, brisket and coffee , I've got the Meat Sweats now . Will have to find a larger location next year and this was more than doubled this year so next year could be even larger .
 
So just ball joints or upgraded lower control arms with pre installed joints ?
Sounds like time for springs as well !
 
What are you doing for an upgrade to the lower control arms? I went Prothane bushings and taller ball joints on mine. Got rid of the squishy Hydromount.
 
I'm not sure why I had to find this out but the bolts holding the MAF sensor in place are are M4 diameter by 1.25 thread pitch and 15mm long. A little bit of red loctite should keep things together. Might cure the hesitation problem I've been having too :o
 
I'm nowhere near. There are a few from that area but nobody that I can think of that might have been in the evacuation zone.
 
I am close, but not near enough to worry and it was going in opposite direction.
I believe is fully under control now, no fire trucks on bisset rd side which is where it started.
Few friends lived in area. but now everyone is aloud to go home.
 
Need to get mine washed and polished before our JDI show and shine on Friday.

in-case anyone is in the Dieppe area on Friday 11am - 1.30pm, feel free to drop by at 100 Midland Drive. We normally have about 30+ vehicles and various displays, fun & games, BBQ, Cavendish Fry Wagon, Silent Auction etc. All money raised goes to the United Way. Afraid you cannot enter your vehicle but come and spend some money!!!!!
 
You must log in or register to reply here.
Back
Top