Search results

You go through tires much quicker than me I’ve only had 2 sets of Pirelli, 1 set of Falkins , plus worn out 2 sets of AS3 Michelins- on the 17” rims . just started a new set of Michelins AS4’s on the 19” in my 15 years of driving with the Mustang

I see the driver cooling Trevor

Congratulations, lots of turns behind that picture !

Got caught up on MVI before it expired the end of April, about 27,000km since the last one 2 years ago. Starting 2026 with 302,500 km on the summer driven car.

I remember a “better to ask for forgiveness than permission “ quote

There is a lot of work, parts to remove to make room to drop the transmission 4” so one bolt can come out holding the shifter to the transmission. The shifter mod is simple if all the parts are machined correctly. I found the quick jacks can also be used as a second and third helper when...

Another 4.6 view

Getting ready for the start of season- if mother nature ever gets back on her meds ! Tried to do some interior cleaning done today, got the dash and carpets cleaned up. Installed a new shifter boot. I tried a repair on some wear area's on the drivers seat - turned out Ok in my books . Got the...

that would have been a wild ride!

yup big dog issues right there

Almost back on the ground

Jacking rail build is now compete - I started with some 2x3 rectangular tube - had to cut it to match the contour and depth needed to be just lower than the pinch weld area and match the slope of the inner rocker ledge. A bit of time spent learning the plasma cutter and all went well. Primed...

When Dads truck was still working for its keep

If I’m paying 300,000 it better be making me money- not that I have the 300,000 to spend

Ordered some steel last night - going to see if home made jacking rails can happen before spring -

I’d say about 20cm here in Enfield, at least the snowblower likes this stuff

I drive the car a lot so I wear some parts out-others time just takes a toll . It’s nice to be able to find a deal - the Steeda billet control arms were off another Maritime Mustang car that got returned to stock so it could be sold a few years ago. I got to be the new parts owner. One never...

Yes. The paint can made an appearance - I cleaned up the shocks and lower control arms while I was there as well . Got axle back under the car and bolted in. Still have driveshaft -rear sway bar and brakes to finish before it gets back on the ground

It’s been a busy couple of weeks - not much time for car stuff when sitting in a hotel room in another province. Finally got everything in the axle and it’s back in one piece, now to get it back under the car and hope for a quiet set up when it’s driving time.